Ich habe mich über eine Hochschule oder Universität beworben. Der Vorgang dauerte 4 Wochen. Vorstellungsgespräch absolviert im Okt. 2016 bei Texas Instruments (Dallas, TX)
Vorstellungsgespräch
Applied through university and had one round of phone interview.
Then had a follow up interview on webex.
I was selected for an on-site interview for the final round in Dallas. It was mostly based out on the resume and a few very basic questions about the projects
Fragen im Vorstellungsgespräch [1]
Frage 1
What is the purpose of kelvin connection to measure the resistance of a wire?
Which region of the transfer characteristics represent an ohmic resistor?
He gave me a 3 end to end diode connected transistors and asked me to find the voltage drop across each of them.
Vorstellungsgespräch absolviert bei Texas Instruments (Bengaluru)
Vorstellungsgespräch
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
Vorstellungsgespräch absolviert bei Texas Instruments (Bangalore Rural)
Vorstellungsgespräch
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Vorstellungsgespräch absolviert bei Texas Instruments
Vorstellungsgespräch
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.
